Fox - Mounting Hardware Stock Item:Mounting Hardware Crush Washer AL 8mm x 41.15mm/1.620 always SPIN the wheel to

always SPIN the wheel to distribute the sealant

5% PU: Palm: 80% Polyester

one side ring

or any situation where a rider wants the lightest setup possible

SUNTOUR - XCM 32 29"

Fox - Mounting Hardware Stock Item:Mounting Hardware Crush Washer AL 8mm x 41.15mm/1.620 always SPIN the wheel toFOX MOUNTING HARDWARE If your rear shock already has the metal hardware pieces pressed into the top and bottom eyelets, follow these steps: Measure the Width: Place the calipers on the outside edges of the hardware. Measure the total width from side to side in millimeters (e. g., 22mm, 30mm). Measure the Hole: Measure the inside diameter of the inner sleeve hole where the bolt passes through (typically 6mm, 8mm, or 10mm). E. g: If your total width is